Header 4

Contact Us


Office phone: 07 4671 0235 Office fax: 07 4671 0407
Email Us

Chemigation Units

Hydra-Fert The pump unit that is simply built to last can provide cost effective solutions to injecting and metering of fertilizers and chemicals.

Where accurate metering of low to high volume liquids is required the Hydra-Fert pump unit can achieve this task. Corrosive and ahrasive solutions are not a problem.

The heart of the Hydra-Fert unit is the Hydra-Cell pump, this industrial quality pump is capable of delivering a repeatahle flow 24 hours a day which makes it suitable for the most demanding injection applications.

The Hydra-Fert unit can be supplied in various drive options, 240v, 415v and bare shaft for V-belt drive. They can be fully automated with existing irrigation controllers.

The versatility of the Hydra-Cell pump is such that other tough agricultural applications including Insecticide, Fungicide and Herbicide spraying can be undertaken by this pump. Because it has a maximum pressure capability of 70 bar ( 1000 psi) other applications such as High Pressure Cleaning, High Pressure Fire Fighting and Powering High Pressure Fogger Systems can also be achieved.

VARIABLE SPEED DRIVE CONTROLS

The Hydra-Fert unit can be supplied with a frequency inverter. This will accept a signal from a flow meter to ramp the motor speed up and down so that a desired injection rate is achieved. These controls can also be programmed with predetermined rates.

TANK MIXING EDUCTOR NOZZLES

Eductor Principles: Eductors use a unique venturi design which enables smaller pumps to circulate large volumes of tank solution. The eductor will circulate four to five litres of solution for each litre pumped.

Eductors are used for mixing chemicals, suspending solids, adjusting pH, "sweeping" debris or sludge toward a filter intake and many other useful applications. Standard material is glass filled polypropylene.

LINE FILTERS

Line filters:
1-1/4" and 1-1/2" BSP threads, max. working pressure 15 bar, filtering capacity 200-280 1/min, cartridge ∅ 58x210mm, fixing points on both sides, polypropylene body, EPDM gaskets.
Self-cleaning line filters:
1-1/4" and 1-1/2" BSP threads, max. working pressure 15 bar, filtering capacity 200-280 1/min, cartridge ∅ 58x210mm, fixing points on both sides, polypropylene body, EPDM gaskets. By-pass min. 30/min.
3" screen filters:
3" BSP threads, filtering capacity 800 l/min, cartridge ∅ 145x320mm, polypropylene body, EPDM gaskets, working pressure 8 bar max (l16PSI max), bleed thread I" BSP (closed)



Below